The Patent Pending Arisaka Indexer is a continuation of our low profile, minimal control accessories. It was developed due to end-user demand for a Q-Sert version to fit the proprietary Q-Sert threaded handguards, and features a slim front-to-back profile and slight radius across both faces.

The Indexer can be used in a variety of ways, but the main intent is to place it between two fingers (usually index and middle). This typically places it further forward on the handguard, which also means it doesn't get in the way when transitioning to kneeling or prone shooting positions, where most people move their support hand towards the rear. Used in this manner, the Indexer makes it much easier to pull the rifle into your shoulder and maintain control while shooting.

Additionally, the wider, flatter profile of the Indexer functions very well as a hand stop or barricade stop, and also works as a forward limit to prevent your fingers from slipping off shorter handguards onto a hot barrel or suppressor.

The contact surface of the Indexer is biased to one end by design due to the wide spacing of the Q-Sert interface mounting points. This allows the user to reverse the Indexer and provides twice as many positions along the length of the handguard to fine tune hand placement.

Height: 1.0"

Width: 0.58"

Length: 2.55"

Weight: 0.8 oz

The Indexer is CNC machined from 6061-T651 aluminum and MIL-A-8625 Type III hard coat anodized. Requires an T25 Torx driver for installation (not included).

Hardware: Two 10-32x3/8" Torx flat head screws.

Made in the USA.