18350 Series Light Kit
18350 Series Light Instructions
The Arisaka 18350 Series Light is a complete illumination package. Simply choose a head, tailcap/remote, and light mount from the drop down menus. Included is the low profile 18350 Series Light Body for an unobstructed, close fit when using an Arisaka Inline, Offset, or Side Scout Mount.
Head options (Check out our blog post for beam comparison images - the E2XTL has the same output as the E2XT):
- Malkoff E2XTL - 500 lumens and 55,000 candela of white light provide a tightly concentrated beam for distance, with a small amount of spill for close range and peripheral lighting. This head will illuminate targets at 100 meters better than the 1500 lumen M600DF because of the significantly higher candela. Run time is 45 minutes with one 18350 lithium-ion rechargeable. Malkoff heads are fully potted to withstand recoil during weapon mounted use. This head can also run off two CR123 cells, but would require switching to an 18650 length body.
- Modlite OKW DF - 680 lumens and 69,000 candela of white light with an even tighter beam profile than the E2XTL. Run time is 30 minutes with 18350. This head can also run off two CR123 cells, but would require switching to an 18650 length body.
- Modlite PLHv2 Dual Fuel - 1350 lumens and 54,000 candela of white light with a blend of spill and throw. Run time is 30 minutes with 18350. This head can also run off two CR123 cells, but would require switching to an 18650 length body.
The 18350 Series Light is compatible with all Scout tailcaps including the Surefire UE and DS, and will also fit in any aftermarket Scout mount, as it retains the mounting holes and square lug interface on the underside of the light body.
Weight (with one 18350, no tailcap): 3.4oz
Length (without tailcap): 3.50"
Power source: One 18350 rechargeable. This light will NOT run off a single CR123 cell. The Malkoff E2XTL and Modlite OKW DF and PLHv2 DF heads can run off two CR123 cells, but require switching to an 18650 length body.
The Arisaka light body, momentary tailcap, and head are CNC machined from 6061-T651 aluminum and MIL-A-8625 Type III hard coat anodized. FDE heads and bodies are Cerakote over type III hard coat anodizing. High quality Buna-N O-rings are included.
Made in the USA.